Bits for sale

[GSouthee]

AS part of my garage clear up and impending engine swap I have several items on Ebay, ie a full set of SU HV2's fully rebuilt with manifolds./ A moss gearbox and a moss selector block with a gear lever.
   
   May suit an Ace or Aceca.
   
   If any one interested let me know, may get a bit cheaper direct.
   
   Cheers Gary

[GSouthee]

Hi  I have been asked the ratios for this box they are as follows
   
   1st 3.37 2nd 1.98 3rd 1.36 top 1.1 R 3.37.
   
   The only number on the gearbox are AC231 stamped on the top selector cover and 80261 OY cast into the side of the gearbox (I assume the casting number)
   
   The ratio are exactly the same as the Ace and Aceca using the Moss gearbox.
   
   If you multiply the ratios by the diff ratios you can check them against your spec sheet.
   
   Cheers all.

[GSouthee]

Hi The first gearbox has been sold and will winging its way to the states in due course.
   
   I will have another one available soon, it is still in my car and can be seen and tested in situ for the next week or so. It is the same ratio's as the Ace and Aceca.
   
   Cheers  Gary

[GSouthee]

Well the spares are flying away, the gearbox is off to Santa Rosa, the Starter to California (both ruddy heavy) and the SU's to Suffolk.
   
   All gone to enthusiasts restoring/rebuilding their cars.
   
   Now have one more Moss gearbox (soon to be out of car), a full Moss bell housing and clutch release mechanism, Dynamo for 2 litre (on Ebay), a 2 litre distributor rebuilt approx 4000 miles ago, comes fitted with electronic ignition (also will include the original points and bits for the purist) and matching coil (make me a sensible offer before it goes on Ebay).
   
   There will be other bits as I proceed.
   
   Cheers Gary